Miller Spectrum 625 X-TREME Owner's Manual download pdf (Page 28)

. A complete Parts List is available at www.MillerWelds.com

OM-254 170 Page 24

Ref. 254 087-A

5-6. Sequence Of Gouging Operation

Connect work clamp to a clean, paint-free

location on workpiece, as close to cutting

area as possible.

Raise trigger lock and press trigger. Pilot

arc starts. Move tip to within approxi-

mately 3/16 in. (4.8 mm). Start gouging

across workpiece surface. Maintain

approximately a 45 angle to surface.

Release trigger. Postflow continues for

approx. 20 seconds after releasing trigger;

arc can be instantly restarted during postflow

by raising trigger lock and pressing trigger.

! The pilot arc starts immediately

when trigger is pressed.

Hold torch at approximately

45 angle to workpiece.

Trigger pilot arc once before starting to gouge.

45

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 43 44

No comments

Miller Spectrum 625 X-TREME Owner's Manual Page 28