Miller PipeWorx 400 User Manual download pdf (Page 2)

2

PipeWorx Power Source Control Panel

with Door Open

1. Process Selection clearly backlights

adjustable controls and lights the appropriate

meter — Stick or DC TIG. TIG Gas Pre-flow

and Post-flow optimized for the application.

2. Optimized Stick Welding Conditions—

Automatically sets the optimum welding

conditions for common E6010 Series and

E7018 Low Hydrogen Series electrodes.

Adaptive Hot Start

™

for Stick arc starts auto -

matically increases the output amperage at

the start of a weld, and prevents the electrode

from sticking.

3. Versatile TIG Arc Starts—Select between

Lift-Arc

™

or high frequency starting with the

push of a button.

4. Memory Card provides the ability to save

the process parameters of all memory

locations. Each operator can have their own

machine settings.

5. Memory stores four programs for each

selection Stick, TIG, MIG (left and right).

This eliminates the need to remember

parameters. The convenient white board

area can be customized using magnetic

strips, grease pencils or erasable markers.

6. Flux-Cored Selection provides the optimum

weld conditions for welding pipe with gas-

shielded flux-cored wires.

7. MIG Starts and Stops are optimized based

on selection of material type, wire diameter

and shielding gas type. No setting required.

8. The MIG-Modified Short Circuit (RMD

®

)

Programs and Pulsed MIG Programs are

synergic programs designed specifically to

provide optimum pipe welding performance

for combinations of wire type, wire diameter

and shielding gas. See pages 4 and 5 for

welding process information.

9. Left/Right Side Feeder Select

10. Remote Program Select allows the welder

to select a stored program without returning

to the power source.

1. Dedicated Stick Connection

2. Dedicated Work Cable Connection

3. Dedicated TIG Torch Cable Connection

4. Dedicated TIG Gas Hose Connection—

Built-in TIG gas solenoid automatically turns

gas on/off in HF or Lift-Arc

™

mode.

5. 115 VAC (10 amp) Receptacle for water

cooler, if used.

6. Dedicated TIG Remote Receptacle

Cable Connection Panel

Note: MIG connections are on rear panel of power source—see Owner’s Manual.

3

10

5

9

6

2

1

7

4

8

PipeWorx Welding System (Continued)

Wind Tunnel Technology

™

and Fan-On-Demand

™

provide system protection

in the dusty environment

of a pipe shop.

Work cable and clamp

(along with regulators and

gas hoses) included in

PipeWorx Accessories

Kit #300 568.

(TIG torch is

optional, see

page 7.)

Typical System with Remote Feeder — See Page 6 for Systems

STICK

WORK

TIG

GAS OUT

2

1

5

3

4

6

14

115VAC 10A

READ OWNER’S MANUAL

NEUTRAL BONDED TO GROUND

CB1

1 2 3 4 5 6 7 8

Comments to this Manuals

No comments