Miller Millermatic 252 Owner's Manual download pdf (Page 15)

. A complete Parts List is available at www.MillerWelds.com

OM-230 693 Page 11

4-4. Connecting To Weld Output Terminals

803 778-A

Y Turn off power before connecting to

weld output terminals.

Y Failure to properly connect weld

cables may cause excessive heat

and start a fire, or damage your ma-

chine.

1 Weld Output Terminal

2 Supplied Weld Output Terminal Nut

3 Weld Cable Terminal

4 Copper Bar

Remove supplied nut from weld output ter-

minal. Slide weld cable terminal onto weld

output terminal and secure with nut so that

weld cable terminal is tight against copper

bar. Do not place anything between weld

cable terminal and copper bar. Make

sure that the surfaces of the weld cable

terminal and copper bar are clean.

Tools Needed:

3/4 in (19 mm)

Do not place

anything between

Correct Installation

Incorrect Installation

weld cable terminal

and copper bar.

4-5. Installing Work Cable And Clamp

Tools Needed:

3/4 in

1 Work Cable

2 Boot

Route cable through front panel

opening. Slide boot onto work

cable.

3 Negative (−) Output Terminal

Connect cable to terminal and

cover connection with boot.

Close door.

804 909-A

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 51 52

Comments to this Manuals

No comments

Miller Millermatic 252 Owner's Manual Page 15

Comments to this Manuals

Related products and manuals for Welding System Miller Millermatic 252