cineline70Fluid HeadOPERATOR’S MANUAL#1055 Cineline 70 Fluid Head
10Unlock Lock3mm Hex KeyCounter ClockwiseClockwiseOperating Instructions4 Camera Plate Lock Adjustment The Camera Plate Lock is designed to s
114.4 Using a 3 mm Hex key unlock the LOCK SCREW (g. 6), then using a broad at screw driver turn the ADJUSTING SCREW (g. 6) in the direction shown
12Operating Instructions5 Counterbalance Control The counterbalance system was designed to neutralise the effect of the camera weight when it is tilt
balancecountertiltpan13Operating Instructions5 Pan / Tilt Drag ControlThe Cineline 70 Fluid Head offers 7 selectable positions of uid drag + zero se
14MaintenanceThe Cineline 70 Fluid Head offers high quality surface coatings. Miller recommends keeping the Fluid Head clean at all times by using sof
15Storage Service, Sales and SupportThe Cineline 70 Fluid Head can be stored for extended periods; Miller recommends storage in a Miller Soft Case and
www.millertripods.comMILLER CAMERA SUPPORT EQUIPMENT30 Hotham Parade Artarmon, Sydney NSW 2064 AustraliaTel: +61 2 9439 6377 Fax: +61 2 9438 2819D87
2Fig. 1Tilt LockFeatures and ControlsPan LockThreaded StudClamp Nut Pan HandleSafety Lock KnobSide Load Lock LeverPan Handle ClampFront Box Mounting
Fig. 1Tilt LockFig. 2Features and ControlsCamera Plate (Arri Type)Tilt Drag ControlCounterbalance SelectorBubble LevelPan Drag ControlAccessory Mounti
Introduction4Safety InstructionsThank you for purchasing the Cineline 70 Fluid Head. The Cineline 70 Fluid Head is purpose-built for lm/digital produ
5Technical DataFig. 3Weight 5.7 kg (12.7 lbs)Payload Range 4.5 – 37.5 kg (9.9 – 82.5 lbs)Maximum Capacity 45 kg (99 lbs)Tilt Drag 7 Selectable uid dr
6Pan HandleIllumination ButtonBubble LevelClamp NutPan Handle ClampFig. 4Operating InstructionsThe operating instructions are described in six steps.
2 Fluid Head Set-up (Tripod Bowl)2.1 Ensure that the TRIPOD BOWL is approximately horizontal. Place the Fluid Head into the TRIPOD BOWL, adjust the
8Operating Instructions3 Camera Set-up3.1 Remove the CAMERA PLATE by pressing and holding the SAFETY RELEASE KNOB then pulling the SIDE LOAD LOCK L
9Fig. 7C of GSide Load Lock LeverSafety Lock KnobCamera Plate (Arri Type)3.4 Align the edge of the CAMERA PLATE with the BASE PLATE, and then side l
Comments to this Manuals